Table of Contents
Where is the OBD port on a 2000 Chevy Tracker?
OBD connector location for Chevrolet Tracker (1989 – 1998)
- The OBD II plug is located above the pedals.
- The OBD diagnostic port is visible between the brake pedal and the gas pedal.
- The OBD port is here.
Where is the OBD connector located?
The OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 – 3 in the diagram below).
Where is a typical OBD II scan tool connector located?
The OBD II connector is typically located inside the vehicle under the dashboard on the drivers side. For vehicles sold in International markets outside the US, the vehicle’s OBD II connector pins can assist in determining whether the Auterra scan tool will work with your vehicle.
Where is the OBD2 port on 2002 Chevy Trailblazer?
The port is under the dash, in-line with your right leg. You will need a code reader.
What is OBD1?
OBD1 is a diagnostic system that only supports cars made before 1996. Introduced in 1991, it does not support all older models. The downside of these scanners is that they are manufacturer specific. One scanner won’t work on two different brands even if they have the same issues.
Where do you plug in an engine code reader?
Plug your car code reader into the diagnostic link connector under the dash (engine off). Then start the vehicle and follow the auto code reading procedure in the instruction manual.
Where do I connect diagnostic tool?
Typically, it is somewhere near the steering wheel, underneath the dashboard. A few cars have the port on the passenger side or somewhere around the center console. Check your car’s user manual for specific details. Turn the car off before plugging the automotive scan tool into the OBD-II port.
Why is my obd2 not working?
The most common cause of an OBD scanner that won’t turn on is a blown fuse on the vehicle’s OBD socket power supply circuit. If the check engine light fails to aluminate, you can be sure the fuse has blown. Checking the vehicle’s fuse box and replacing the blown fuse fixes the issue.
What is the difference between an OBD reader and scanner?
A code reader is a simplified version of a scan tool, but it’s only capable of performing basic scans of trouble codes. A scan tool can read and clear trouble codes, and it may also provide advanced data reading and playback features, knowledge bases, diagnostic procedures, and built-in testing equipment.
What is OBD2 connector?
If you purchased a car after 1996, it probably has an OBD-II port. OBD-II is an on-board computer that monitors emissions, mileage, speed, and other data about your car. It’s connected to the Check Engine light, which illuminates when the computer detects a problem.
Does car have to be running to use OBD2 Scanner?
Always turn the ignition on or have the car running according to the instructions in the manual. Failure to do this might corrupt the scanning software. It’s also very important that you drive around with the manual for the specific scanner model that you’re using.