Where is the fuse box on a GMC?

Where is the fuse box on a GMC?

The engine compartment fuse block is in the engine compartment, on the driver side of the vehicle.

Where is the light fuse located?

Like all fuses, the brake light system fuse can be found in the power distribution center, which is under the dashboard or tucked away underneath the hood.

Where is the fuse for the engine?

engine compartment
Locate your vehicle’s fuse box. The fuse box is normally located in either the engine compartment, in the driver’s side foot well or in the glove compartment. If you are struggling to locate the fuse box then check your owner’s manual or have a search online.

How do you check fuses in fuse box?

Lay the rubber mat on the floor in front of the fuse box and stand on it. Open the box door and turn on the flashlight to inspect the fuses. Look closely at each fuse. The window on a good fuse will be clear.

What is SEO retained accessory power?

The retained accessory power module takes control of any accessory driven by its relay. When the key is turned on, the relay is closed providing power to the accessories. The relay remains on for up to 20 minutes after the key is off, allowing the radio to keep playing or the power windows to be rolled up.

Where is the trailer light fuse on a 2014 GMC Sierra?

For your 2014 GMC Sierra 1500, the running light fuse is in the #15 position on the fuse box which is labeled as “Trailer Park Lamps”.

Which fuse is for taillights?

The tail light fuse may be located in either the fuse panel in the front passenger side of your vehicle or in the main fuse box under the hood. Once you’ve opened either the panel or the main fuse box, locate the tail light fuse.

How do you remove a fuse from an engine compartment?

Part 1 of 1: Removal of the fuse box

  1. Materials Needed.
  2. Step 1: Disconnect the battery cable.
  3. Step 2: Locate and open the fuse panel.
  4. Step 3: Disconnect fuse box power supply.
  5. Step 4: Disconnect the panel’s housing.
  6. Step 5: Remove and label the wiring harnesses.
  7. Step 6: Confirm replacement and transfer fuses.

Share this post