Table of Contents
What fuse controls power windows?
If none of the windows will move when you press their switches, the fault could be a blown fuse for the power window circuit, or an open or short in the wiring circuit that supplies the power window circuit, or a problem with wiring harness or module that controls the power windows.
Is there a fuse for car windows?
The most common power window mechanism is pretty basic. Window regulators are high-current devices, and the fuse is sized to just barely be able to open all four windows together. Age and a few sticky window channels can pop a fuse. Turn the key to the Run position, but don’t start the car.
Where is the fuse for car windows?
Changing a Fuse. Locate and open the fuse box. It should be located inside the car as a part of, or near, the dash. Check your owner’s manual to locate that operates the windows.
Can a blown fuse cause windows not to work?
Perhaps the easiest power window fault to diagnose and repair, the fuse is the small link between the power window and the car’s main electrical circuitry. If the fuse blows, all power windows in the vehicle (as well as any other electric devices that share the fuse) will stop functioning altogether.
What would cause a car window to stop working?
If only one window stops working, the problem could be a bad relay, fuse issue, bad motor, or the power window switch has failed. The most common reason for one window to stop working is the switch, so this should be looked at by a professional mechanic to have your power window switch replaced.
Does each power window have it’s own fuse?
Check the fuse Other cars have individual fuses for each window motor so failure will only affect the one window. In some cars the fuse is in the main fusebox but many makers use in-line fuses so check with your manual to find where the fuse is and replace it if blown. Then test the window.
Can you drive with a blown fuse?
If the replacement fuse of the same rating blows in a short time, there is probably a serious electrical problem with your vehicle. Leave the blown fuse in that circuit, and have your vehicle checked by a qualified mechanic.
How much does it cost to fix a power window?
The average time to replace a power window motor is 2.1 hours. That averages out to roughly $120 to $150 in labor time plus the cost of the motor itself. This can usually bring the entire job to a total of anywhere from $200 to $300, depending on make and model.
How do you replace a fuse in a car window?
How to Change a Fuse
- Locate your car’s fuse panel.
- Take off the fuse panel’s cover.
- Locate the blown fuse.
- Remove the broken fuse.
- Insert a replacement fuse of the correct amperage—make note of the fuse panel and your owner’s manual on this one.
- Keep a few extra fuses of various amperages in your glove box.
How do you get under the hood of a car?
Hood Latch: The hood latch is used to access under the hood. Typically, a button or lever inside the vehicle on the driver’s side pops the hood to allow access to the hood latch. Serpentine Belt: The serpentine belt wraps around all the pulleys in the engine.
Where is the fuse box on a Chevrolet Cobalt?
This 2010 Chevrolet Cobalt Fuse Diagram is for an engine compartment fuse box and floor console fuse box, also called the body control module (BCM). The engine compartment fuse box is located on the driver’s side under the hood. The floor console BCM fuse box is located on the passenger side behind a panel on the floor console.
Where is the remote jumper cable under the hood?
In a Chrysler with a wheel-well battery, there is a remote positive (“+”) terminal under the hood located in the fuse box (number 6 in Figure 3 below). It has a red, plastic cover on it. In order to jump your car, pull off the red cover and attach the positive (red, or “+”) jumper cable to this terminal.
What do you need to know about under the hood?
Information Labels: These labels provide information about your specific vehicle. Hood Latch: The hood latch is used to access under the hood. Typically, a button or lever inside the vehicle on the driver’s side pops the hood to allow access to the hood latch. Serpentine Belt: The serpentine belt wraps around all the pulleys in the engine.