Table of Contents
How do I access my interior fuse panel?
The interior fuse box is on the driver’s lower left side. To remove the fuse box lid, pull it toward you and take it out of its hinges. The under-hood fuse box is located near the back of the engine compart- ment on the driver’s side. To open it, push the tabs as shown.
Where is the other fuse box?
All the electrical circuits in your car have fuses to protect them from a short circuit or overload. These fuses are located in three fuse boxes. The auxiliary fuse box is located on the driver’s side near the brake fluid reservoir. To open it, push the tab on each side and remove the lid.
How do you get to the passenger compartment fuse box?
The fuse panel is in the right-hand side of the passenger footwell behind a trim panel. To remove the trim panel, pull it toward you and swing it away from the side. To reinstall it, line up the tabs with the grooves on the panel, and then push it shut.
Why do cars have two fuse boxes?
Most vehicles are equipped with two fuse boxes. One is located in the engine compartment and is used to protect engine components such as the cooling system, anti-lock brake pump, and the engine control unit. The fuse box houses a variety of fuses and relays in one convenient place, protected from outside elements.
How many fuse boxes does my car have?
Most vehicles are equipped with two fuse boxes. One is located in the engine compartment and is used to protect engine components such as the cooling system, anti-lock brake pump, and the engine control unit.
Why do cars have 2 fuse boxes?
The fuse is there to protect the wire, which would be much harder to replace than the radio. Most cars have two fuse panels. The one in the engine compartment holds the fuses for devices like the cooling fans, the anti-lock brake pump and the engine control unit — all of which are located in the engine compartment.
How do you remove a car fuse without the tool?
You can try a pair of tweezers. If you see tubular glass, look for one that’s black inside, or no longer has its filaments intact. If you can’t pry it out with your fingers, you can use a bent paper clip or a small set of pliers.